"Jartible" (...)
Mensajes: 773
Registrado: 30 Ene 2009, 14:28
Ubicación: CADIZ: Jerez de la Frontera
Traduciendo las Reglas Art.4 CASCO, CUBIERTA Y ACCESORIOS
4. HULL, DECK AND DECK FITTINGS
4.1. Reinforcements for the purpose of strengthening or repairing the hull or deck may be added anywhere inside the hull.
4.2. The layout of the deck may be modified to accommodate rigging controls.
4.3. Alternate deck fittings for the jib pivot, mast step, shrouds, backstay, sheet exit guides and fairleads are permitted and their location is left to the skipper’s discretion.
4.4. New or different sheet access holes, rudder linkage holes, or holes for each of a charging jack, receiver antenna, and battery switch may be added in any location on the deck provided the hole is no larger than necessary to accommodate the fitting, but never larger than 1/2 (12.7mm) inch in diameter.
4.5. The KIT rudder linkage hole in the cockpit bulkhead, the plastic pushrod exit bushing and plastic upper rudder shaft tube bushing may be used, modified, or omitted to allow for alternate rudder control systems and any such system, including modification to the deck for such systems, is left to the skipper’s discretion.
4.6. The aft cockpit cover may be used, modified, or omitted. A substitute material may be used to cover all or part of the cockpit.
4.7. The KIT-supplied steering columns and wheels, winches and cleats may be omitted.
4.8. A single drain hole, not exceeding 1/2 inch (12.7mm) in diameter and for the sole purpose of removing water from the hull, may be located anywhere on the deck.
4.1. Reinforcements for the purpose of strengthening or repairing the hull or deck may be added anywhere inside the hull.
4.2. The layout of the deck may be modified to accommodate rigging controls.
4.3. Alternate deck fittings for the jib pivot, mast step, shrouds, backstay, sheet exit guides and fairleads are permitted and their location is left to the skipper’s discretion.
4.4. New or different sheet access holes, rudder linkage holes, or holes for each of a charging jack, receiver antenna, and battery switch may be added in any location on the deck provided the hole is no larger than necessary to accommodate the fitting, but never larger than 1/2 (12.7mm) inch in diameter.
4.5. The KIT rudder linkage hole in the cockpit bulkhead, the plastic pushrod exit bushing and plastic upper rudder shaft tube bushing may be used, modified, or omitted to allow for alternate rudder control systems and any such system, including modification to the deck for such systems, is left to the skipper’s discretion.
4.6. The aft cockpit cover may be used, modified, or omitted. A substitute material may be used to cover all or part of the cockpit.
4.7. The KIT-supplied steering columns and wheels, winches and cleats may be omitted.
4.8. A single drain hole, not exceeding 1/2 inch (12.7mm) in diameter and for the sole purpose of removing water from the hull, may be located anywhere on the deck.
Joaquín / OSO POLAR II / ESP-02